Rulebook – Updated for 2019 Rules
Amendments to the Rules
Amendments to the 2019 Rules –
April 15, 2019
Due to safety reasons and precautions we can no longer allow items to wave or be attached to the race cars that can and will impede the drivers vision. Thanks for your understanding on this but we only want everyone to be safe!
December 22, 2018
Enduro > Car > Section H > Added “Hulling permitted”
Enduro > Engine > Section E > Changed Carburetor Paragraph to say > Carburetor: The REQUIRED carburetor is six hundred (600) C.F.M. or five hundred (500) C.F.M. two (2) barrel, Holley carburetor; Part number 01850, 04412, or 80457. The choke horn and list number must remain intact. Removal of the choke butterfly and choke assembly is permitted. No polishing or other modifications except changing jets will be permitted. . Carburetor spacer one piece adaptor Mr. Gasket type 0.750in. Rear jet plates with center hung floated bowls permitted. Dual lines are ok. Quadra jet must be OEM factory stock except for the following options: Removal of choke plates, shaft, and choke mechanism. Side load or front load OK. Carburetor must pass Waycross Motor Speedway No Go Gauges.
Sections i and ii remain unchanged.
Enduro > Drive Train and Suspension > Section H > Aftermarket tubular upper A frames within stock specifications
Enduro > Drive Train and Suspension > Added Section J > Rear trailing arms must be stock length top and bottom
Enduro > Drive Train and Suspension > Added Section K > No mono ball
Enduro > Brakes > Section A > Stock type master cylinder, booster optional. Or dual master cylinder ok. No brake adjusters. 4-wheel disc brakes OK